Plastic granulator mould

Use the mold of the plastic granulator, and unpack the packaging after the extrusion die arrives to check that the packaging is intact: after unpacking, remove the packing list and unpack and check. Instruction manuals and other technical documents, according to the contents of the packing list, inventory the entire mold, accessories, special tools, etc. one by one.

Under normal circumstances, the water and gas systems of the granulator should not collude with each other. To remove the water pipe joint of the die set die, a cooling system and vacuum system of the die set should usually not leak. The vacuum pipe joint shall be clearly marked and shall not affect the connection of the pipe.

The general technical requirements and status of the extrusion die of the granulator: The forming parts are generally made of stainless steel and other materials with corrosion resistance. The extrusion die is especially used when the extrusion material is modified polyvinyl chloride. And quenched and tempered to above HRC24 to ensure a certain service life. There shall be no defects such as bruises, scratches, burrs, attachments and rust. The working appearance of the die, setting die and its parts should be smooth. The plastic granulator reminds to prevent sudden changes in the cross section and the stagnation area. The die channel system should be gentle along the melt flow direction.